Painting Post
Posted: Wed Jun 08, 2016 2:42 pm
So I built a chaplin with lots of magnetized parts: 
Now how do I prime and base coat them without haveing paint pool up on whatever flat surface Im using to hold the parts. Well since the arms have pieces of tin on them I decieded to use more magnets and do this:
Its simple. A piece of plywood, wood dowel, 1 wood screw and a bunch of nails. I put a small magnet on the end of each nail. I did not glue it as IF I had a magnet part to put up the sides may not match up. I was able to prime and base coat a bunch of parts and not have paint pool.
Now how do I prime and base coat them without haveing paint pool up on whatever flat surface Im using to hold the parts. Well since the arms have pieces of tin on them I decieded to use more magnets and do this:
Its simple. A piece of plywood, wood dowel, 1 wood screw and a bunch of nails. I put a small magnet on the end of each nail. I did not glue it as IF I had a magnet part to put up the sides may not match up. I was able to prime and base coat a bunch of parts and not have paint pool.