Page 1 of 1

Looking for old west/cowboy/frontier themed models

Posted: Sat Sep 25, 2010 11:29 pm
by spiralingcadaver
Hi, I'm looking for some old west or cowboy models (male or female is fine) for proxies in an army (specifically, for those aware of that it means, I'm planning a Talion charter with a west theme, using converted solos and warjacks to fit)-

I'm looking for 35mm models that have or can be modded to have the following:
20-ish with pistols, hopefully with melee weapons, or with room for them. Most with single pistols or in poses where they could be replaced by melee weapons
3-6 with rifles
10-20 with melee weapons (or could be modded for them), preferably improvised
1-2 small cannon weapon crews
1 heavy cannon crew

I've seen some good ones from black scorpion and a few from reaper, but that's about it

Thanks in advance for any suggestions (and, if you happen to have them, I might be interested in buying/trading for them- not a high priority, but something I'd like to work on now and then)

Re: Looking for old west/cowboy/frontier themed models

Posted: Sun Sep 26, 2010 2:40 am
by HarlequinZero
Not sure of how the scales match up to PP, but both Artizan and Foundry make quite a few Old West minis.

Re: Looking for old west/cowboy/frontier themed models

Posted: Sun Sep 26, 2010 10:15 am
by kturock
jeff valent studios makes minis for deadlands.

http://www.jeffvalentstudios.com/store/ ... a3f468b270

Re: Looking for old west/cowboy/frontier themed models

Posted: Sun Sep 26, 2010 4:48 pm
by spiralingcadaver
Thanks, they look a little small (selection/range) but may work. I also found this collection in case other people are interested in old west minis:
http://www.erichotz.com/miniatures1.html